기술 팁 - TA Instruments - Page 3

Pellet Polymer Samples on the Ares G2

3-Point Bending Clamp Setup on the ARES-G2 Rheometer

Penetration Clamp Installation & Calibration on the Discovery DMA 850

Fiber Clamp Calibration on the Discovery DMA 850

Microhygrostat Operation with the TAM IV

Loading the Injection Syringe for the Nano ITC

Hangdown Wire Replacement for the Discovery 5500 TGA

Adjusting Upper Plate Height for Soft Samples on the DTC-300

Utilizing Cement Analysis with the TAM Air Isothermal Calorimeter

Analyzing Data with the Cement Analysis Software for the TAM Air Isothermal Calorimeter

Surface Diffusion Geometry Installation for the DHR-RH Accessory

Compression Clamp Installation & Calibration for the DMA 850

Non Solid Sample Cell Setup for the DTC-300

Changing the Thermal Resistance Stack on a DTC-300 Heat Flow Meter

Proper Adjustment of the Pressure Release Lifter

Preparation & Use of the Pressure Release Lifter

Introduction To The Cleaning Station for Nano ITC, Nano DSC, and Affinity ITC

Manually Loading Titrants on the Affinity ITC

Installation of the Immersion Accessory for the RSA-G2

Installation & Calibration of the Relative Humidity Accessory for the Discovery Hybrid Rheometer

Shear Sandwich Clamp Installation & Calibration for the Discovery DMA 850

Intro and Details of WinTest DMA Software v8 (Full Playlist)

Temperature Ramp & Time Test Setup in WinTest DMA Software v8 – (7 of 7)

Configuring the Waveform Setup Panel in WinTest DMA Software v8 – (6 of 7)

Completing the Test Setup Panel in WinTest DMA Software v8 – (5 of 7)

Application of the Specimen Insertion Utility in WinTest DMA Software v8 – (4 of 7)

Compliance Compensation Configuration in WinTest DMA Software v8 – (3 of 7)

Specimen Type Configuration in WinTest DMA Software v8 – (2 of 7)

An Introduction & Overview of WinTest DMA Software v8 – (1 of 7)

Film Tension Clamp Installation & Calibration for the Discovery DMA850

Configuring the Solution Calorimeter for use on the TAM IV

Connecting an RCS Cooler System to a Discovery DSC

Force Calibration with the Q400 TMA

How to Accurately Calculate the Heat of Dissolution of Potassium Chloride

Film Fiber Probe Installation & Calibration – TMA Q400

Calculating the Auto Zero Offset for the Film/Fiber Accessory on the TMA Q400

Potassium Chloride Dissolution Measurements with the Precision Solution Calorimeter

Three Point Bend Clamp Installation & Calibration for the DMA850

Installation and Calibration for the UV Accessory on the Ares G2 Rheometer

Expansion and Penetration Probe Installation on the TMA Q400