Specimen Type Configuration in WinTest DMA Software v8 – (2 of 7)
In this special techtip on the new WinTest DMA Software version 8 for Electoforce systems, we walk through how to configure the specimen type feature!
An Introduction & Overview of WinTest DMA Software v8 – (1 of 7)
In this first of seven special tech tips on the new WinTest DMA Software v8, product manager Troy Nickel walks us through all the exciting updates and new features of WinTest DMA Software version 8!
Film Tension Clamp Installation & Calibration for the Discovery DMA850
In this TA Techtip we show how to properly install and calibrate the Film Tension Clamp available on the Discovery DMA850.
Configuring the Solution Calorimeter for use on the TAM IV
In this TA Techtip, we’ll walk through the correctly configuring the solution calorimeter for use in the TAM IV system.
Force Calibration with the Q400 TMA
Q Series Trade-In The Q Series™ instruments will enter their End-of-Life at the end 2024. Repair and maintenance will be done on “best-effort” after 2024. However, it should be noted that our ability to make these repairs is subject to availability of parts. In the attempt to facilitate the transition to the current Discovery Series,…
Film Fiber Probe Installation & Calibration – TMA Q400
Q Series Trade-In The Q Series™ instruments will enter their End-of-Life at the end 2024. Repair and maintenance will be done on “best-effort” after 2024. However, it should be noted that our ability to make these repairs is subject to availability of parts. In the attempt to facilitate the transition to the current Discovery Series,…
Calculating the Auto Zero Offset for the Film/Fiber Accessory on the TMA Q400
Q Series Trade-In The Q Series™ instruments will enter their End-of-Life at the end 2024. Repair and maintenance will be done on “best-effort” after 2024. However, it should be noted that our ability to make these repairs is subject to availability of parts. In the attempt to facilitate the transition to the current Discovery Series,…
Three Point Bend Clamp Installation & Calibration for the DMA850
In this TA TechTip, we walk through the proper steps for installation and calibration of the three point bending clamp for the Discovery DMA850
