Consejos técnicos

Ver todo Caucho Dilatometría ElectroforceTT Folleto de microcalorimetría General Reología Software Thermal Applications Thermal Conductivity

Cantilever Clamp Installation on the ARES-G2

Data Acquisition Types Available in WinTest Software

Expansion & Penetration Probe Installation – Discovery TMA 450 Thermomechanical Analyzer

Installation of the Film/Fiber Probe on the Discovery TMA 450

How to Load Low Viscosity Liquid Samples on a Rotational Rheometer

Cell Constant & Temperature Calibrations for the Discovery X3 DSC

An Introduction to Batch Processing in TRIOS

Setting Up Experiments for the New Discovery X3 DSC

Setting Up a DMA Compression Test on the ARES-G2 Rheometer

TRIOS Features for Plotting and Analysis of Fatigue Test Data

TRIOS Integration for Data Acquisition and Overlay from Samples Undergoing Failure

Introducing the DSC Sample Cutting Kit

Cycle Indirect Block Waveform in WinTest Software

Geometry Selection for Testing Solid Samples on a Rheometer

Performing Tzero Calibrations for the Discovery X3 DSC

An Introduction To TRIOS Express with the New Discovery Hybrid Rheometer

Proper Sample Loading with the Brand New Discovery Hybrid Rheometer

Enabling Waveform Compensation on an ElectroForce Test System

Using the High Force Compliance Compensation Kit for ElectroForce Load Frames

Assembling and Mounting a Bioreactor Chamber on an ElectroForce BioDynamic Instrument

Performing Weight Calibration on the Discovery SDT 650

Performing Force Calibration on the Discovery TMA 450

Film Tension Clamp Installation & Calibration for the Discovery DMA 850

Heat Capacity Calibration on the Discovery SDT 650

Converting Mass Spectrometry Data to NIST File Formats

Temperature Ramp Tests on the DMA 850

Extensional Viscosity Fixture Installation & Use on the ARES-G2

Setting Up the Blending Gas Delivery Module Accessory

Installation of the Dielectric Accessory for ARES-G2 and RSA-G2 Rheometers

Pellet Polymer Samples on the Ares G2

3-Point Bending Clamp Setup on the ARES-G2 Rheometer

Penetration Clamp Installation & Calibration on the Discovery DMA 850

Fiber Clamp Calibration on the Discovery DMA 850

Microhygrostat Operation with the TAM IV

Loading the Injection Syringe for the Nano ITC

Hangdown Wire Replacement for the Discovery 5500 TGA

Adjusting Upper Plate Height for Soft Samples on the DTC-300

Utilizing Cement Analysis with the TAM Air Isothermal Calorimeter

Analyzing Data with the Cement Analysis Software for the TAM Air Isothermal Calorimeter

Surface Diffusion Geometry Installation for the DHR-RH Accessory

Compression Clamp Installation & Calibration for the DMA 850

Non Solid Sample Cell Setup for the DTC-300

Changing the Thermal Resistance Stack on a DTC-300 Heat Flow Meter

Proper Adjustment of the Pressure Release Lifter

Preparation & Use of the Pressure Release Lifter

Introduction To The Cleaning Station for Nano ITC, Nano DSC, and Affinity ITC

Manually Loading Titrants on the Affinity ITC

Installation of the Immersion Accessory for the RSA-G2

Installation & Calibration of the Relative Humidity Accessory for the Discovery Hybrid Rheometer

Shear Sandwich Clamp Installation & Calibration for the Discovery DMA 850